|
- An OpenWrt Beginners Guide - Installing and Using OpenWrt - OpenWrt Forum
Connect to your OpenWrt device using ssh, copy output of below commands and post it using the preformatted text button (redact passwords, MAC- and public IP addresses)
- OpenWrt 24. 10. 1 - Service Release
The OpenWrt community is proud to announce the newest stable release of the OpenWrt 24 10 stable series
- OpenWrt Forum
OpenWrt - Wireless Freedom
- Best Newcomer Router - 2025 - OpenWrt Forum
The world moves on, and the recommendations in Best "newcomer router" - 2024 have evolved, too The next post lists the current winners I'll keep it updated as I get new recommendations My criteria remain the same: inexpensive, easy to flash, full ability to fight bufferbloat, etc These are the critical characteristics: Supports official STABLE OpenWrt 24 10 2 No snapshot builds Clear one
- Cant update, opkg update fails - OpenWrt Forum
* opkg_download: Check your network settings and connectivity I think my network settings and connectivity are setup and working correctly the error message would
- OpenWRT 24. 10: changing default IP from cmd line
Hello: In an attempt to put a RPi 3B+ to use, I downloaded and set up OpenWRT (24 10 0, r28427-6df0e3d02a) I did this by dd'ing the image to a 32Gb micro sdcard, no browser involved It boots properly and but there is the problem of the OpenWRT default IP (192 168 1 1) which conflicts with my FO router IP which is also 192 168 1 1 I could edit the setting in rootfs etc * (?) but I don't know
- Installing OpenWRT 24. 10 on Ubiquity ER-X EdgeOS V2. 0. 9-hotfix7
Recipe for flashing OpenWRT 24 10 onto Ubiquity Edgerouter X (ER-X) running stock EdgeOS V2 0 9-hotfix7 Download the 22 03 factory image openwrt-ramips-mt7621-ubnt_edgerouter-x-initramfs-factory tar from stman's github repo Flash via EdgeOS UI and reboot via EdgeOS UI The device will reboot and be available on IPv4 192 168 1 1 on ETH1 afterwards Set host pc's ethernet connection to use
- The opkg install command failed with code 255 - OpenWrt Forum
1-when i try to update package list or install any package i get this message " Unable to execute opkg update command: SyntaxError: Unexpected end of JSON input" 2-after refreshing the luci software and trying to install any package i get this message: openwrt ver:
|
|
|